About Our Company
Dhil Al Al Shams begins Since our meetings take place in your home or office, we’ll…
- Email Us : dhilalshamsshedfix@gmail.com
- Contact Us : +971 50 756 0324
-
18Since 2005.
-
40Professionals
Powder Coating and Hydraulic Shearing
Powder Coating
There are very specialized operations where powder coatings of less than 30 micrometres or with a Tg below 40 °C are used in order to produce smooth thin films. One variation of the dry powder coating process, the Powder Slurry process, combines the advantages of powder coatings and liquid coatings by dispersing very fine powders of 1–5 micrometre sized particles into water, which then allows very smooth, low film thickness coatings to be produced
Making the Colors
One variation of the dry powder coating process, the Powder Slurry process, combines the advantages of powder coatings and liquid coatings by dispersing very fine powders of 1–5 micrometre sized particles into water, which then allows very smooth, low film thickness coatings to be produced
Read More
Iron Cutting
1. Cutting the double sheets is forbidden, trimming the edge of the rough selvedge is forbidden. Cutting the loose narrow and short material is forbidden. 2.The gap between the cutting board should be adjusted according to the thickness of the sheet, and it shall not be 1/30 greater than the sheet. The cutting board should be fasten and firm, the upper and down cutting board surface should be kept parallel, the operator inspect it after adjustment in order to avoid the accident.
Read More
